My drivers are fully up-to-date, I'm seeing no extreme heat on any components, and everything seems to be performing well at the hardware level. So it's not hardware, so it has to be software.

A check of Task Manager shows no performance spikes, only about 24% processor utilization, 4 to 6 GB of RAM usage (out of 32), 2-ish GB RAM (out of 8) usage, etc. Within a minute or two the lag reaches unplayable levels, but switching over to something else and the computer is moving flawlessly. I go into the game and immediately notice some lag. The game, itself, is suddenly completely lagging out, but the computer itself is not having issues. I don't know *IF* I'll be able to, because I think I'm running into Unreal Engine bugs. I haven't gotten T2 gear operational yet, so I cannot comment on that. I have my Cloutium pump pack with the 4 water pressure, I think it a t2Īt what pressure will make the belts 'fast'? Originally posted by golddragonclaw:Thanks, I went to Cloutium pipes and no longer using iron I'm still building a temp setup at Icehelm, while I continue to dig out the rest of the space. I have not yet played around with them, but I'm sure they're documented somewhere as to exactly what they do. I don't know if the pressure goes all the way up to the Pressure of the Cloutium Intake or if the Iron Pipe(s) creates a max pressure CAP.Įdit: There are also Pressure Booster Hooks that you can create on the Forge at Icehelm. What I don't know, and have no plans to test at this time, is what happens if you have a Cloutium Intake, a run of Cloutium Pipes, a single (or multiple) Iron Pipe, and then install a Cloutium Pressure Booster. At that point, the calculations all start over from the beginning. the length of your Pipe run until the next Pressure Booster. So the factor is not how many Belts, how many Miners, or how many Harvesters, but rather a function of your Intake Pipe vs. It drops the pressure to the MAX pressure of an Iron Pipe.

Also, placing an Iron Pipe AFTER a Cloutium Intake creates a limiting factor. Cloutium Pipes deplete pressure at 2.5 per Pipe, while Iron Pipes depletes the pressure at 3.0 per Pipe. Cloutium Intake has a higher pressure than an Iron Intake. The reason it depends, is based on your Pipes. The answer, at this time, is: It depends. Originally posted by golddragonclaw:For belts, how many belts per tp is best or good?

Max out tank in iron force